Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Install the new seal.

-- If required, move the adjusting screw in the brake caliper back a little using a socket -1- to make it easier to install the parking brake motor.

-- Position the parking brake motor in direction of -arrow 1-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure that the seal is seated correctly

-- Turn the parking brake motor -arrow 2- so that the hole for the bolt -a- and the thread in the brake caliper housing -b- are covered.

NOTE:

Make sure that the parking brake motor is seated flush against the brake caliper housing.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of damaging the threads.

Position the bolts by hand and screw in a few turns.
If the thread is damaged, the entire brake caliper must be replaced.

-- Tighten the parking brake motor bolts.

-- Connect the connector -arrow- to the parking brake motor.

Courtesy of AUDI OF AMERICA, LLC

-- Install the rear wheel. Refer to WHEELS AND TIRES .

-- Switch the ignition on.

-- After entering the VIN, select Guided Functions .

-- Perform a basic setting.

Suspension/brake system
	01 OBD-capable systems
		53 Electromechanical parking brake control module J540
			53 Electrical parking brake functions
				53 46 Basic setting

-- Continue to follow the instructions in the vehicle diagnostic tester display.