Overview - Front Brakes, 1LP
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 196 NmNOTE:
Loosen only the coil spring bolts
- 196 Nm
- Brake Caliper
- Do not loosen any screws on the brake caliper.
Refer to BRAKE CALIPER, REMOVING AND INSTALLING
Refer to BRAKE CALIPER, REPLACING
NOTE:Depending on the model there are two balance weights installed in each front brake caliper.
- Do not loosen any screws on the brake caliper.
- Bleed Screw
- 13 Nm
- Brake Rotor
- Always replace on both sides of the axle
- Allocation. Refer to the parts information.
- Wear limit
- Refer to BRAKE ROTOR, REMOVING AND INSTALLING
- Refer to BRAKE ROTOR, REPLACING
- Clean and lubricate contact surfaces between brake rotor and wheel hub. Refer to the parts information.
- Bolt
- 10 Nm
- Brake rotor to wheel hub
- Brake Pad Wear Wire
- On inner brake pad
- Brake Pads
- With the brake pad wear wire on the inside of the brake pad
- Check the pad thickness. Refer to appropriate service information
- Wear limit. Refer to appropriate service information.
- Before installing the brake pads, clean the pad guide surface and coat it with a film of grease. Grease. Refer to parts information.
- Make sure it is in the installation position
Refer to BRAKE PADS, REMOVING AND INSTALLING
- Brake Pad Pins
- Make sure it is in the installation position
- Press all the way from the inside toward the outside
- Brake Pad Spring
- Make sure it is in the installation position
- Brake Line Hose
- 19 NmNOTE:
Do not loosen when changing brake pads
- 19 Nm
NOTE:
Coat the brake pad - backing plate with grease pate and coat the guide pin with lithium grease. Refer to the parts information.