Brake Caliper, Removing And Installing, Steel Brakes, 1LA/1LJ: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
NOTE:
Replace the brake carrier bolts after removing.
WARNING:
Health Risk.
- Do not blow out brake system with compressed air.
NOTE:
Use only mineral spirits to clean the brake caliper.
-- Clean the brake caliper.
-- Carefully slide the brake caliper with the brake carrier and the installed brake pads over the brake rotor.
-- Tighten the new bolts -arrows-.
-- Engage the brake hose -1- at the bracket.
-- Install the brake pad wear indicator sensor. Refer to BRAKE PAD WEAR INDICATOR WIRE, REMOVING AND INSTALLING, STEEL BRAKES, 1LA/1LJ .
NOTE:
Make sure that the connector and brake hose are routed correctly.
Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.
-- Install the front wheel. Refer to WHEELS AND TIRES .
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.