Brake Caliper, Removing And Installing, 1LP: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening Specifications
NOTE:
Use new bolts. Refer to parts information.
Use only mineral spirits or commercially available brake cleaner to clean the brake caliper.
-- Clean brake caliper.
-- Carefully press the brake caliper with the brake carrier and the installed brake pads over the brake rotor.
-- Tighten the brake caliper with the new bolts.
- Tightening Specifications
-- Install the brake hose into the bracket on the pivot bearing.
-- Attach the brake pad wear wire.
-- Mount the wheels. Refer to WHEELS AND TIRES .
-- Check brake fluid level, and fill if necessary.
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.