Mounting Bracket, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Install the accelerator pedal module. Refer to ACCELERATOR PEDAL POSITION SENSORS -G79 - / - G185 -, REMOVING AND INSTALLING [For engine(s) CAED, CTUA, CREH, CEUC, CTGE, CREC, CYNB]

-- Install the brake pedal. Refer to BRAKE PEDAL, REMOVING AND INSTALLING .

-- Install the pedal bracket, with the brake pedal installed, and the accelerator pedal module.

The pedal bracket must fit into the guides in the bulkhead.

-- Install and tighten the brake booster/mounting bracket bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts -arrows- and the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Attach the brake pedal to the brake booster. Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .

-- Install the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

WARNING:

Risk of accident!

Make sure the brakes are working correctly before driving the vehicle for the first time.