Windshield Wiper Arms, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

There Is A Risk Of Damaging The Windshield Wiper Axles.

The windshield wiper axles can get damaged when removing the windshield wiper arms without using the :T10369/1 .

NOTE:

If The Windshield Wiper Motor Is To Be Run During The Work Procedure, The Front Lid Must Be Closed. Otherwise, The Power Supply To The Wiper Motor Will Be Interrupted.

-- Bring the windshield wiper into the service position. Refer to WINDSHIELD WIPER, BRINGING INTO SERVICE POSITION .

-- Pry the caps -arrows- off of the windshield wiper arms -1- with a screwdriver.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nuts -2- several turns.

-- Position the :T10369/1 on the windshield wiper arm -1- as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Position the thrust piece -2- on the windshield wiper axle.

-- Turn the bolt -3- clockwise until the windshield wiper arm is removed from the windshield wiper axle.

-- Remove the nuts completely and remove the windshield wiper arms.