Transfer Fuel Pump -G6-, CHECKING: Assembling
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Assembly is performed in the reverse order of disassembly, noting the following:
- The ignition must be off.
NOTE:
Decrease the fuel pressure by opening the drains -B, C- and letting the fuel run into the measuring container before removing the pressure gauge -1-.
-- Remove the :VAS6550 with the connecting lines.
-- Attach the fuel supply line so that it clicks into place.
-- Press the fuel supply line on again and pull to make sure the connector coupling is engaged correctly.