Cylinder Head Cover Left, Installing And Removing, Vehicles With Two Turbochargers: Installing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

Replace the cylinder head seal if it is damaged.

-- Clean any oil or grease off the sealing surfaces.

NOTE:

Note the expiration date of the sealing compound.

Courtesy of AUDI OF AMERICA, LLC

-- Cut the tube nozzle at the front marking (nozzle diameter: about 2 mm).

-- Apply a sealant bead -arrows- to both the cylinder head transition and the timing chain guard upper section.

Courtesy of AUDI OF AMERICA, LLC

Sealant bead thickness: approximately 2 mm

-- Tighten cylinder head cover bolts. .

-- Install the Intake Flap Motor -V157-. Refer to Intake Flap Motor -V157-, REMOVING AND INSTALLING .

-- Install the fuel injectors. Refer to FUEL INJECTORS, REMOVING AND INSTALLING .

-- Perform a leak test on the fuel system. Refer to FUEL SYSTEM LEAK TEST .