Exhaust Pipes/Mufflers, Separating: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Separate the exhaust pipes at a right angle at the notches -arrow- using a :VAS6254 .
-- When installing, position the clamping sleeves -arrows- on the center of the separating point
-- Install double clamps so that the bolt ends do not project over lower edge of double clamp.
- Installed position: the threaded connectors face forward.
-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .