Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The Transmission Is Removed:
- Refer to TRANSMISSION, REMOVING [7-SPEED DUAL CLUTCH TRANSMISSION 0CK] and/or TRANSMISSION, DISASSEMBLING AND ASSEMBLING [7-SPEED DUAL CLUTCH TRANSMISSION 0CJ, 0CL, 0CK, 0DN, 0DP] .
- Refer to TRANSMISSION, REMOVING [8-SPEED AUTOMATIC TRANSMISSION 0BK AWD] .
-- Insert the :10-201 to loosen the bolts.
CAUTION:
The Outer Surface Of The Bearing Flange At The Drive Plate Could Be Damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate and sensor wheel.