Pistons, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston using a commercially available piston ring compressor.

Installed Position:

Piston. Refer to PISTON INSTALLED POSITION .
Connecting rod. Refer to CONNECTING ROD INSTALLED LOCATION .

-- Install the connecting rod bearing cap according to the marking.

-- Install The Baffle Plate. Refer to BAFFLE PLATE TIGHTENING SEQUENCE AND SPECIFICATIONS .

-- Install the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head. Refer to CYLINDER HEAD, INSTALLING .