Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING [7-SPEED DUAL CLUTCH TRANSMISSION 0CJ, 0CL, 0CK, 0DN, 0DP] and/or TRANSMISSION, REMOVING [7-SPEED DUAL CLUTCH TRANSMISSION 0CK] or TRANSMISSION, REMOVING [8-SPEED AUTOMATIC TRANSMISSION 0BK AWD] .
-- Insert the :10-201 to loosen the bolts.
CAUTION:
The Outer Surface Of The Bearing Flange At The Drive Plate Could Be Damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts and remove the drive plate.
-- Remove the Engine Speed Sensor -G28- sensor wheel