LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 975 (Crankshaft, Cylinder Block- CEUC, CRDB, CTGE, CWUB, CWUC) >> Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Vibration Damper, Removing And Installing >> Installing

Vibration Damper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

Install The Bolts With Locking Compound; Locking Compound.

Clean the threaded holes with a thread tap.

-- Be careful of the alignment sleeve when installing the vibration damper.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Audi S6/RS6/RS7 

-- Install The Radiator, With The Fan Shroud. Refer to RADIATOR, REMOVING AND INSTALLING, AUDI S6/S7 .

Audi S7 

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals