Crankshaft, Measuring Axial Clearance
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Dial Gauge Holder :VW387
- Dial Gauge - 0-10mm :VAS6079
-- Install the :VAS6079 with the :VW387 on the cylinder block as shown in the illustration.
-- Place the dial gauge against the crankshaft counterweight.
-- Press the crankshaft against the dial gauge by hand and set the gauge to "0".
-- Press the crankshaft off the dial gauge and read the measurement.
- Axial Clearance: 0.090 To 0.251 mm.