LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Climate Control System (Service Information - (Coolant Circuit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Display And Control Head >> Display And Control Head, Removing And Installing >> Climatronic Control Module -J255-, REMOVING AND INSTALLING >> Installing

Climatronic Control Module -J255-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following: 

-- When replacing a Climatronic Control Module -J255- control head, pay attention to the exact allocation. Refer to the Parts information.

After replacing/installing the Climatronic Control Module -J255- control head, always perform the following procedures on the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Perform and/or check the coding.

-- Perform the basic setting.

-- Read the Diagnostic Trouble Code (DTC) memory (and clear the input for the currently displayed entry).

-- Check the adaptation.

-- If necessary, perform the output diagnostic test.

scientia non olet · About LEMON Manuals