LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Climate Control System (Service Information - (Coolant Circuit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Display And Control Head >> Component Location Overview - Display Control Head

Component Location Overview - Display Control Head

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA87-11548Courtesy of AUDI OF AMERICA, LLC
  1. A/C Display Control Head
    • There are different versions. Refer to the Parts information.
    • Overview. Refer to OVERVIEW - DISPLAY AND CONTROL HEAD .
    • Removing and installing. Refer to Climatronic Control Module -J255-, REMOVING AND INSTALLING .
      NOTE:

      Depending on the Audi A6 e-tron version, the measured value for the Evaporator Vent Temperature Sensor -G263- can be evaluated by the Climatronic Control Module -J255- control head (as on all other vehicles of this model line) or by the Thermal Management Control Module -J1024-. Use the Vehicle Diagnostic Tester in the "Guided Fault Finding"  function and refer to the Appropriate Wiring Diagram.

      If the measured value is evaluated by the Thermal Management Control Module -J1024- on the Audi A6 e-tron (and is transmitted via the data bus to the Climatronic Control Module -J255-), there is a different version of the Climatronic Control Module -J255- installed. Use the Vehicle Diagnostic Tester in the "Guided Fault Finding"  function and refer to the Parts information.

  2. Front Information Display Control Head -J685-
    • Multi Media Interface (MMI) Display
    • There are different versions. Refer to the Parts information.
    • Certain selected functions (and various auxiliary functions for the A/C system) are displayed via the MMI display on the Climatronic Control Module -J255- control head. Refer to Infotainment/MMI Operating Instructions.
  3. Multimedia System Control Head -E380-
    • Different version. Refer to the Parts information.
    • So that the different A/C system functions can be selected and displayed on the Multi Media Interface (MMI) display, the correct version of the Climatronic Control Module -J255- control head must installed, coded, and adapted.
    • To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function
  4. Rear A/C Display Control Head -E265-