Thermal Management Control Module -J1024-, REMOVING AND INSTALLING (AUDI A6 E-TRON): Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following.
-- Check the bracket -A- for damage and the installed control module -B- for proper latching (at the tab -E-).
-- Insert the Thermal Management Control Module -J1024- -C- and check for correct seating of the retainer -B-.
-- Check that the connector -A- is correctly seated and locked.
-- Check the DTC memory of the Thermal Management Control Module -J1024- and delete any displayed faults if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.
-- Check the basic setting of the Thermal Management Control Module -J1024- and perform if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding" .