Left/Right Rear Upper Body Vent Temperature Sensor -G635- / -G636-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Mark the connectors -1 and 5-.
NOTE:
If the connections -1 and 5- are switched, the respective measured values for the control head will not be recognized and the controls for the A/C system will be faulty. use the Vehicle Diagnostic Tester in "Guided Fault Finding" function.
-- Disconnect the connector -1- and turn the Left Rear Upper Body Vent Temperature Sensor -G635- -2- counterclockwise and remove it from the mount.
-- Disconnect the connector -5- and turn the Right Rear Upper Body Vent Temperature Sensor -G636- -4- counterclockwise and remove it from the mount.