LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Climate Control System (Service Information - (Coolant Circuit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Additional Components For Control And Regulation >> Air Ionization System Control Module -J897-, REMOVING AND INSTALLING >> Installing

Air Ionization System Control Module -J897-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following: 

NOTE:

Odors in the air flowing by are neutralized at ionizer.

In the case of vehicles without an air ionization system, seal the installation opening in the air duct in an air-tight manner, for example, with adhesive tape.

-- Replace damaged or defective seals on the ionizer.

-- Install the right B-pillar air duct. Refer to B-PILLAR AIR GUIDE, REMOVING AND INSTALLING .

After completing the repair work, perform the following operations on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding"  function:

-- Check the Diagnostic Trouble Code (DTC) memory and delete any currently displayed entries.

scientia non olet · About LEMON Manuals