LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 967 (Engine Cooling System (Service Information - CYNB - 1 Of 2)) >> 19 Cooling System >> Radiator/Coolant Fan >> Radiator, Removing And Installing >> Removing

Radiator, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove The Front Bumper Cover. Refer to ATTACHMENTS, REMOVING AND INSTALLING .

-- Remove the charge air cooler. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .

-- Remove The Right Headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .

GWWA19-12095Courtesy of AUDI OF AMERICA, LLC
WARNING:

There Is A Risk Of Injury If The Radiator Fan Turns On By Itself.

  • Disconnect the connectors before working near the fan shroud.

-- Disconnect the coolant fan connector -1- by sliding the retainer back -arrow- and pressing the release down.

-- Remove the bolts -arrows- and air guide -1-.

GWWA10-11452Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the air guide -1-.

GWWA24-10872Courtesy of AUDI OF AMERICA, LLC
NOTE:

Ignore item -2-.

-- Open the clamps -1 and 2- and remove the connection from the radiator.

GWWA19-10542Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- from the A/C Pressure/Temperature Sensor -G395-.

GWWA87-11501Courtesy of AUDI OF AMERICA, LLC
CAUTION:

There Is A Risk Of Damaging The Condenser And Refrigerant Lines And Hoses.

  • Do not bend, twist or stretch the refrigerant lines and hoses.

-- Release the left and right clamp in direction of -arrow B-.

-- Remove the condenser -1- first at the right from the radiator in direction of -arrow A-.

-- Then guide out the condenser at the left while doing so pay attention to the refrigerant lines.

-- Pivot the condenser to the left side.

-- Free up the wiring harness -2-.

GWWA19-11648Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -3 and 4- but only loosen the bolt -5-.

-- Pivot the impact absorber -1- forward -arrow-.

-- Release the left and right radiator retaining pins and remove by pulling upward in direction of -arrows-.

GWWA19-11979Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right bolt -1- and remove the radiator console with the radiator from the lock carrier in direction of -arrow-.

GWWA19-10543Courtesy of AUDI OF AMERICA, LLC

-- Remove the radiator.

-- Press the fan shroud left and right locking tabs at the same time in direction of -arrow- and remove the fan shroud upward from the radiator.

GWWA19-10445Courtesy of AUDI OF AMERICA, LLC