Coolant Fan Control Module, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front noise insulation. Refer to FRONT NOISE INSULATION, REMOVING AND INSTALLING .
WARNING:
There Is A Risk Of Injury If The Radiator Fan Turns On By Itself.
- Disconnect the connectors before working near the fan shroud.
-- Remove the coolant fan connector -1- from the bracket and disconnect it by sliding the retainer back in direction of -arrow- and pressing the release down.
-- Free up the electrical wiring harness to the coolant fan control module.
-- Disconnect the connectors -2 and 3-.
-- Remove the bolt -arrow- and the coolant fan control module -1-.