LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 967 (Engine Cooling System (Service Information - CYNB - 1 Of 2)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Coolant Valves, Removing And Installing >> Transmission Coolant Valve -N488-, Removing And Installing >> Removing

Transmission Coolant Valve -N488-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove The Noise Insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

GWWA19-11641Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the :3094  and then remove them.

-- Remove the nuts -arrows- and then remove the Transmission Coolant Valve -N488-.

scientia non olet · About LEMON Manuals