Valve, Removing And Installing At Service Connection On Low And High Pressure Side: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Install the valve -1- in the service connection using a suitable adapter from the :T10364 (for the tightening specification, refer to SERVICE CONNECTION DIFFERENCES, DEPENDING ON REFRIGERANT (R134A OR R1234YF) ).

-- Evacuate and fill the refrigerant circuit. Refer to appropriate service information. .

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Read the information for starting the A/C system after installing the A/C compressor. .

-- Check the Diagnostic Trouble Code (DTC) memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.