LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 965 (Climate Control System (Service Information - (Refrigerant Circuit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Refrigerant Circuit >> Receiver/Dryer, Removing And Installing >> Receiver/Dryer, Removing And Installing At Condenser (Not For AUDI A6 E-Tron) >> Notes

Receiver/Dryer, Removing And Installing At Condenser (Not For AUDI A6 E-Tron): Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The receiver/dryer may be attached to or integrated in the condenser, depending on the version of the condenser. If the condenser has an integrated receiver/dryer, replace the dryer cartridge. Refer to DRYER BAG/DRYER CARTRIDGE, REMOVING AND INSTALLING .

WARNING:

Danger due to refrigerant coming out under pressure.

Danger of frost bite to skin and other parts of the body.

  • Evacuate the refrigerant and immediately open the refrigerant circuit afterward.
  • If more than 10 minutes have elapsed since evacuating the refrigerant and the refrigerant circuit was not opened, evacuate the refrigerant again. Pressure in the refrigerant circuit is caused by evaporation.
scientia non olet · About LEMON Manuals