Vehicle, Lifting: Procedure:
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Applies for vehicles with an air suspension ("adaptive air suspension"): before lifting activate vehicle lift mode. Refer to VEHICLE LIFT MODE, ACTIVATING .
-- Applies to the RS models: pull the sill panel reinforcement cover down -arrow- and remove.
-- Front: place the hoist mounting plate on the raised plastic mounts -arrows- on the bottom of the side sill trim panel.
-- Rear: place the hoist mounting plate on the raised plastic mounts -arrows- on the bottom of the side sill trim panel.
NOTE:
The impressions on the side sill trim panel mark the positions of the mounting points.