Wiper Blades, Checking For Damage, Version 2

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Step 1 - Service Position

-- Turn on the ignition and activate the MMI.

-- Select the function button CAR .

-- Under >>System<< or >>Car-Systems<<, follow the menu structure:

Service & Checking
Wiper change position

-- Using the MMI control knob switch on the windshield wiper service position.

Step 2 - Testing

-- Lift the windshield wiper and check each wiper blade for breaks, cuts, rough areas and other signs of damage.

-- Repeat the test for the rear window.

-- If damage was detected, replace the respective wiper blade. For the windshield wiper system, refer to WIPER BLADE, REMOVING AND INSTALLING . For the rear window wiper system, refer to WIPER BLADE, REMOVING AND INSTALLING .

NOTE:

There are additional versions for adjusting the service position. Refer to WIPER BLADES, CHECKING FOR DAMAGE, VERSION 1 .