Procedure: Step 2 - Removing the Spark Plugs, Left Cylinder Bank:

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the connector -1- for the Engine Coolant Level Warning Switch -F66-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- from the coolant expansion tank.

-- Set aside the coolant expansion tank with the coolant hoses attached -arrows-.

-- Release the connectors -2, 3, 4, 5, 6, 7, 8 and 9- are remove from the cam adjustment actuator.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1- from the Camshaft Position Sensor 2 -G163-.

-- Remove the connector strip bolts.

-- Release the connector from the ignition coils -arrows- and disconnect all the connectors at the same time from the ignition coils.

-- Move the connector strip slightly to the side. Make sure to not kink or damage the lines.

-- Place the :T40039 on the topmost thick rib and pull all the ignition coils one after the other off of the spark plugs in the direction of the -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Using the :VAS3122B , remove the spark plugs from the cylinder head.