Service Interval Display, Resetting Service Event

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off, refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect " Working with Guided Fault Finding " by removing v and pressing Accept .

-- Switch to the "Special functions " tab.

-- Service Interval, Resetting with ODIS (select the corresponding service).

-- Start the program using Perform test... .

-- Continue the program sequence.

NOTE:

Refer to the appropriate service information for which service channel to reset and for what data to enter.