8-Cylinder Gasoline Engine 4.0L TFSI: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit :SMN372500
- Torque Wrench 1410 :VAG1410 , measuring range: 4 through 20 Nm
- Or: Electronic Torque Wrench 3-60Nm :VAS6583 , measuring range 3 to 60 Nm
Tightening Specification Table for Installation:
| Component / Fastening Element | [Nm] |
|---|---|
| Oil drain plug for oil pan | 20 |
| Oil drain plug oil filter screw cap | 4 |
Requirements:
- Engine oil temperature must be at least 90 °C (194 °F).
Removal Procedures:
-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .