Step 1 - Brake Charger/Bleeder Unit, Connecting:
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the cap -1- from the brake fluid reservoir.
-- When the screen is installed, extract the brake fluid from the reservoir using the suction hose from the :VAS5234 until the fluid level meets the lower edge of the screen. Make sure that no brake fluid runs through the screen after extracting.
-- Attach the adapter -1- to the brake fluid reservoir.
-- Connect the hose -2- of the :VAS5234 to the adapter.
-- Adjust the pressure on the :VAS5234 . Refer to the brake charger/bleeder unit owner's manual for the pressure value.