LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (General Maintenance (2 Of 2)) >> Maintenance >> Maintenance Work >> Battery, Determining And Entering Charge Level (Soc) >> Vehicle Without Active Transport Mode >> Procedure:

Vehicle Without Active Transport Mode: Procedure:

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch on the :VAS6161  and select "new vehicle quality control test".

-- Measuring the voltage between the battery terminal clamps with the :VAS6161  .

-- The following actions are derived from the test result:

Battery tester display: Action:
"Battery good" No further measure necessary.
"Immediately fully charge." Charging the battery. Refer to BATTERY, CHARGING .
"Battery defective" Charge the battery (refer to BATTERY, CHARGING ) and attach the "faulty battery" mirror hanging tag.
NOTE:

If using the :VAS6161  it must be determined if the most current software is used.

If when measuring the charge level (SOC) with the :VAS6161  is not possible measure the battery voltage. Refer to BATTERY VOLTAGE, MEASURING .

scientia non olet · About LEMON Manuals