LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (General Maintenance (2 Of 2)) >> Maintenance >> Maintenance Work >> Battery, Checking Electrolyte Level >> Battery Without Visual Indicator

Battery Without Visual Indicator

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

Tightening Specification Table for Installation: 

Component / Fastening Element [Nm]
Pressure reservoir nut 9

The battery is located in the luggage compartment under the luggage compartment floor.

Removal Procedures: 

-- Raise the luggage compartment floor covering and secure.

-- Applies to vehicles with air suspension ("adaptive air suspension"): Remove the nuts -arrows- and move the pressure reservoir with the lines -1- still attached and the solenoid valve block -2- to the side.

GWWA43-10202Courtesy of AUDI OF AMERICA, LLC

-- Remove the vehicle tool box.

   

Procedure: 

-- Check the battery housing for the following:

-- Replace damaged batteries.

-- Check the electrolyte level of all battery cells with the markings in the housing.

-- If the electrolyte level of at least one battery cell is under the MIN mark, replace the battery.

Installation procedures occur in reverse order. While doing so, note the tightening specifications. Refer to BATTERY WITHOUT VISUAL INDICATOR  for the installation tightening specification table.

NOTE:

Use a bright flashlight to see the MIN and MAX markings better in the housing.

If it is difficult to read the battery, use a small mirror to check the electrolyte level while holding a bright flashlight at a right angle behind the battery cells.