Battery Transport Mode, Deactivating

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off, refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnosis mode and start diagnosis.

-- Perform the vehicle identification.

-- Deselect " Working with Guided Fault Finding " by removing v and pressing Accept .

-- Switch to the " Special Functions " tab and select the following program:

19 - Activate/deactivate battery transport mode

-- Start the program using Perform test... .

-- Continue the program sequence.

NOTE:

Battery transport mode ensures that the vehicle will be able to start.

When battery transport mode is on, many functions such as the radio do not work or are limited.