Bumper Cover Lower Section, Removing And Installing, AUDI RS6: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the mount for the tail pipe trim. Refer to TAIL PIPE TRIM MOUNT, REMOVING AND INSTALLING, AUDI RS6 .
-- For vehicles with an automatic rear lid opener, disconnect the connector -1-.
-- Cut the cable tie -2-.
-- Remove the power rear lid opener sensor -3 and 4- from the clips -arrows-.
-- Release the tab -2- -arrow- while removing the lower section -1- from the bumper cover -3- at the same time.