Part 2
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Turbocharger Assembly
- with:
- High Pressure Turbocharger
- Low Pressure Turbocharger
- Removing and installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, VEHICLES WITH TWO TURBOCHARGERS .
- Do not separate.
- with:
- Vacuum Diaphragm
- for Low Pressure Turbocharger
- Removing and installing. Refer to LOW PRESSURE TURBOCHARGER VACUUM DIAPHRAGM, REPLACING .
- Adjusting. Refer to LOW PRESSURE TURBOCHARGER VACUUM DIAPHRAGM, REPLACING .
- Tightening specification for the actuator rod lock nut: 7Nm
- Nut
- 7 Nm
- Lock Washer
- Replace
- Bolt
- 7 Nm
- Bracket
- For Turbocharger Control Module 1 -J724-
- Turbocharger Control Module 1 -J724-
- For High Pressure Turbocharger
- Bolt
- 7 Nm
- Lock Washer
- Replace
- Actuator Rod
- Bolt
- 23.5 Nm
- Lock Washer
- Replace
- Vacuum Diaphragm
- for Turbine Switch-Over between High and Low Pressure
- With Control Valve Position Sensor -G584-
- Removing and installing. Refer to TURBINE SWITCH-OVER VACUUM DIAPHRAGM, REPLACING .
- Adjusting. Refer to ADJUST THE TURBINE SWITCH-OVER VACUUM DIAPHRAGM .
- Tightening specification for the actuator rod lock nut: 11 Nm
- Bolt
- 23.5 Nm
- Lock Washer
- Replace