LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 961 (Turbocharger System (Service Information - CPNB)) >> 21 Turbocharger, Supercharger >> Turbocharger >> Overview - Turbocharger >> Overview - Turbocharger, Vehicles With Two Turbochargers >> Part 1

Part 1

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Turbocharger, Vehicles With Two Turbochargers Exploded View
GWWA21-10586Courtesy of AUDI OF AMERICA, LLC
  1. EGR Pipe
    • To cooler for exhaust gas recirculation
    • If the screw-type clamps were loosened, then the EGR pipe and the screw-type clamp must always be replaced
    • Tightening specification and sequence. Refer to appropriate service information. .
  2. Seal
    • Always replace
  3. Union Nut
    • 25 Nm
      NOTE:

      When loosening the threaded connection counter-hold at the adaptor guard, during assembly check that the adaptor guard is secure.

  4. Oil Return Pipe
  5. Bolt
    • 9 Nm
  6. O-ring
    • Always replace
  7. Bolt
    • 9 Nm
  8. Seal
    • Always replace
  9. Seal
    • Always replace if damaged.
  10. Bolt
    • 9 Nm
  11. Connection
  12. Bypass valve
    • Installed position
  13. Clamp
    • Installed position
    • 6 Nm
  14. O-ring
    • Always replace
  15. Seals
    • Always replace
  16. Banjo Bolt
    • 15 Nm
      NOTE:

      When loosening the threaded connection counter-hold at the adaptor guard, during assembly check that the adaptor guard is secure.

  17. Oil supply line
  18. Seals
    • Always replace
  19. Banjo Bolt
    • 15 Nm
  20. O-ring
    • Always replace
  21. Intermediate Pipe
  22. O-ring
    • Always replace
  23. Connecting pipe
  24. Seal
    • Always replace
  25. Charge Air Pressure Sensor 2 -G447-
    • 25 Nm
  26. Bolt
    • 7 Nm
  27. O-ring
    • Always replace
  28. Banjo Bolt
    • 35 Nm
      NOTE:

      When loosening the threaded connection counter-hold at the adaptor guard, during assembly check that the adaptor guard is secure.

  29. Banjo Bolt
    • 35 Nm
      NOTE:

      When loosening the threaded connection counter-hold at the adaptor guard, during assembly check that the adaptor guard is secure.

  30. Seals
    • Always replace
  31. Seals
    • Always replace
  32. Coolant Supply Line
  33. Bolt
    • 9 Nm
  34. Union Nut
    • 25 Nm
      NOTE:

      When loosening the threaded connection counter-hold at the adaptor guard, during assembly check that the adaptor guard is secure.

  35. Turbocharger Assembly
  36. Bolt
    • 9 Nm
  37. Coolant Supply Line
  38. Bolt
    • 9 Nm
  39. O-ring
    • Replace
  40. Bolt
    • Tightening specification and sequence. Refer to appropriate service information. .
GWWA26-11175Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals