Repairing Can Bus Wires

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Observe general notes for repairs on the vehicle electrical system. Refer to VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .

Unshielded, twisted two-wire lines -1 and 2- with a cross section of 0.35 mm ² or 0.5 mm² can be used as CAN-Bus wiring.

Courtesy of AUDI OF AMERICA, LLC

Repairs on CAN-Bus wires can be performed with repair wire with matching cross section and also with twisted wires "green/yellow" or "white/yellow" from the parts information.
When repairing CAN bus wires, both wires must be same length. When twisting together wires -1 and 2-, the lay length of A = 20 mm (0.78 in.) must be observed.
While doing this, no section of the wire, for example, in area of crimp connectors -arrow-, may be greater than B = 50 mm (1.96 in.) without twisting of the wires.
Wrap repair points with yellow adhesive tape to mark a performed repair.