Removing Insulation From The Shield

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Push the locking pin -1- all the way into the rotating cutting piece.

-- Push the antenna wire -2- all the way into the rotating cutting piece. The locking pin -3- can not be seen completely.

Courtesy of AUDI OF AMERICA, LLC

-- Push the blade holder -1- against the axle of the rotating cutting segment until it locks into place. The gap -2- under the blade holder is completely closed.

-- Hold the antenna wire so that it cannot turn.

-- Turn the rotating cutting segment -3- 2 times in direction of -arrow- until it starts to turn easily.

Courtesy of AUDI OF AMERICA, LLC

-- Pull the release pin -1-. The blade holder unlocks and separates from the antenna wire.

-- Push the locking pin -2- all the way into the rotating cutting piece. The antenna wire is pushed out of the rotating cutting segment.

-- Remove insulation from the antenna wire.

-- Remove any insulation remaining on the rotating cutting segment.