Vehicle Diagnostic Tester, CONNECTING: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Engage the parking brake or operate the electromechanical parking brake.
-- Shift the shifter lever into neutral or place the selector lever in the "P" position.
-- Turn off the ignition and connect the Vehicle Diagnostic Tester to the Data Link Connector (DLC) with the diagnostic cable -arrow-.
-- When using the :VAS5054A or the :VAS5055 pay attention to the Operating Instructions.
-- Turn on the ignition.
-- Turn off all electrical consumers.
NOTE:
If a error message appears on the screen of the Vehicle Diagnostic Tester. Refer to the Operating Instructions.