Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the ground cable from the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING . .
-- Release the retainer in direction of -arrow A- and open the cover in direction of -arrow B-.
-- Remove the wires -2, 3, 5, 6, 7 and 8-.
-- Disconnect the connector -1-.
-- Remove the nuts -arrows- and remove Terminal 30 Wire Junction -TV2- from the plenum chamber bulkhead.