Relay Panel And Fuse Panel In Plenum Chamber E-Box, Removing And Installing, Vehicles With 3.0L TDI Engine (Ea897 Gen I): Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the bolts -arrows- and remove the cover -1- for the E-Box.

GWWA97-11390

Courtesy of AUDI OF AMERICA, LLC

-- Release the fasteners in direction of -arrows-, remove the relay panel with the fuse panel -1-, free it up and set it on the engine.

GWWA97-11899

Courtesy of AUDI OF AMERICA, LLC

-- Release the tab in direction of -arrow-, push Fuse Panel A -SA- -2- to the rear and disengage it from the relay panel -1-.

GWWA97-10872

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip and remove the auxiliary fuse panel -2-.

GWWA97-10873

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips in direction of -arrows- and remove the relay -1- and the control modules from the relay panels.

-- Open the clips in direction of -arrows- and press the relay panel -3- toward the rear and out of the bracket -4-.

GWWA97-10874

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- and remove the connector terminal -1- from the bracket.