Relay And Fuse Panel In Plenum Chamber E-Box, Removing And Installing: Removing

-- Disconnect the ground cable from the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the washer fluid reservoir filler neck. Refer to WASHER FLUID RESERVOIR FILLER NECK, REMOVING AND INSTALLING .

-- Release the retainer in direction of -arrow-, remove the engine control module -1- and move it to the side with the wires still connected.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the cover -1- for the plenum chamber E-Box.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1- and remove the nut -2- for the wire.

Courtesy of AUDI OF AMERICA, LLC

-- Open the retainers in direction of -arrows- and remove the relay panel with the fuse panel -4- and set aside.

-- Remove the nut -3- for the wire.

-- Release the tab in direction of -arrow-, push fuse panel A -2- to the rear and disengage it from the relay panel -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip and remove the auxiliary fuse panel -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips in direction of -arrows- and remove the relay -1- and the control modules from the relay panels.

-- Open the clips in direction of -arrows- and press the relay panel -3- toward the rear and out of the bracket -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- and remove the connector terminal -1- from the bracket.