Fuse Panel A -SA-, REMOVING AND INSTALLING, IN PLENUM CHAMBER E-BOX: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the relay panel and fuse panel and move them to the side with the relay and fuse panels still connected. Refer to RELAY AND FUSE PANELS IN E-BOX, REMOVING AND INSTALLING .
-- Release the tab in direction of in direction of -arrow-, push Fuse Panel A -SA- -2- to the rear and disengage it from the fuse panel -1-.
-- Unlock the release and remove it from the fuse panel.
-- Remove the fuses from the fuse panel.
-- Open the clips in direction of -arrows- and remove the fuse panel cover.
-- Pull off retaining strip -1- for the connectors in direction of -arrow- and remove the connectors from the plug-in socket
NOTE:
Check the exact assignment in the current wiring diagram. Refer to the appropriate WIRING DIAGRAM.