Front Seat Control Module Bracket, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front seat control module:
- For the memory seat/steering column adjustment control module. Refer to SEAT/STEERING COLUMN ADJUSTMENT CONTROL MODULE WITH MEMORY FUNCTION, REMOVING AND INSTALLING .
- For the seat ventilation control module (integrated in the seat heating). Refer to SEAT VENTILATION CONTROL MODULE (INTEGRATED IN SEAT HEATING), REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706- - market-specific. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
-- Press the pin -2- out of the clip -arrow A- in the bracket -1- in the direction of the seat cushion using an upholstery needle, for example.
-- Remove the pin that was pressed out from the seat pan.
-- Remove the support foot -2- from the upper frame of seat pan -1-, unclipping clip -arrow A- at the upper seat frame.
-- Detach retaining tabs -arrow B- on both sides.
-- Carefully remove bracket from the seat pan in direction of -arrow-.