Seat Angle Adjustment Motor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove bolt -2- for seat angle adjustment motor (preset by the manufacturer) adjusting spindle -1-.
CAUTION:
Risk of damage to the bushing -1- in the bearing point -2- (adjusting spindle/seat pan bolting).
- The bushing cannot be replaced with shop materials.
- If the bushing is damaged, the corresponding assembly parts must be replaced.
-- Disconnect harness connector -3- at the seat angle adjustment motor.
-- Remove the bolts -1- and the seat angle adjustment motor -4-.