Connectors, Disconnecting

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The connector station is located in the vehicle floor under the front seat area.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .

-- Push the headrest into the lowest position.

-- Move the front seat all the way to the rear and then into its highest position.

-- Disconnect the battery Ground (GND) cable with the ignition turned on. Refer to BATTERY .

-- Unclip the cover -1- in the front using the :3409 and remove cover in direction of -arrow- from the connector station -2-.

-- Remove wiring bracket -3- at the top from the connector station by releasing retaining tabs.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The number of connectors may vary depending on equipment. The description shows the version with the most equipment possible.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Disconnect side airbag electrical harness connector -1- by releasing retaining tabs.

2 - Seat Heating

4 - Seat Adjustment Voltage Supply

5 - Seat Belt Latch