LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Seats System (Upholstery & Covers - Service Information)) >> Seat Upholstery, Covers >> Rear Seat Covers And Cushions >> Headrest Cover And Cushion, Removing And Installing >> Installing

Headrest Cover And Cushion, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert cushion with proper fit in the cover.

-- Insert headrest support in the cushion with cover.

-- Close the closure by first clipping the lower U-channel of the cover into the headrest support.

-- Clip the edge of the cover with the lower flat channel on the cover into the U-channel.

-- After closing the closure with a needle or pointed object, line up the cover and the channels.

-- Make sure the cover lies on the padding without any wrinkles and without seam markings.

Install in reverse order of removal.

scientia non olet · About LEMON Manuals