Headrest Cover And Cushion, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the headrest. Refer to HEADREST, REMOVING AND INSTALLING .

-- Open the side openings -arrows- on the cover -1-.

-- Insert the :3409 or a flat-head screwdriver between the openings -1- in direction of -arrow A-.

Courtesy of AUDI OF AMERICA, LLC

-- Tension the lower U-channel -3- in direction of -arrow B-.

-- Remove the upper side of the cover with the flat channel -2- from the U-channel.

-- Open the zipper by inserting the :3409 or a flat-head screwdriver between the zipper and the cover.

Courtesy of AUDI OF AMERICA, LLC

-- Tension the lower U-channel -1- in direction of -arrow A-.

-- Remove the upper side of the cover with the flat channel -2- from the U-channel -1-.

NOTE:

The cover must be completely open to remove the padding.

-- Pull off cover and cushion over the headrest support and remove headrest support.

-- Remove cushion -1- out of cover -2-.

Courtesy of AUDI OF AMERICA, LLC