Divided Rear Seat Backrest
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The rear seat backrests in the Sedan are illustrated.
- Center Support
- Removing and installing. Refer to MOUNT/SLEEVE/PINS, REMOVING AND INSTALLING, REAR SEAT BACKREST .
- Screws
- 20 Nm
- Quantity: 4
- Inner Mounting Pin
- 13.5 Nm
- For the rear seat backrest
- Quantity: 2
- Removing and installing. Refer to MOUNT/SLEEVE/PINS, REMOVING AND INSTALLING, REAR SEAT BACKREST .
- Rear Center Armrest
Vehicles with:
- With pass-through door
- With storage compartment
- Overview. Refer to OVERVIEW - CENTER ARMREST .
- Right 2/3 Rear Seat Backrest
Vehicles with:
- Backrest release - only Avant
- Backrest heater
- Pass-through
- Removing and installing. Refer to DIVIDED REAR SEAT BACKREST, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- For the correct tightening specification for vehicles with side airbags. Refer to OVERVIEW - REAR SIDE AIRBAG .
- Side Cushion
Vehicles with:
- Rear side airbag
- Removing and installing. Refer to SIDE CUSHION, REMOVING AND INSTALLING .
- Engage in the seat belt guide at the top first
- Right Head Restraint
- Removing and installing. Refer to HEADREST, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
- Rear Center Belt Guide
- Only with 3-person rear seat
- Replace the entire belt guide if damaged.
- Removing and installing. Refer to REAR SEAT BELT GUIDE IN REAR SEAT BACKREST, REMOVING AND INSTALLING .
- Headrest in the Center
- Only with 3-person rear seat
- Removing and installing. Refer to HEADREST, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
- Cover
- For The center bracket
- Press on until it engages audibly
- Bolt
- 9 Nm
- Left Head Restraint
- Removing and installing. Refer to HEADREST, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
- Trim
- For locking with locking cylinder
- Removing and installing. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Locking Mechanism
- For the rear seat backrest
- Quantity: 2
- Removing and installing. Refer to REAR SEAT BACKREST LOCKING MECHANISM, REMOVING AND INSTALLING .
- Left 1/3 Rear Seat Backrest
Vehicles with:
- Backrest release - only Avant
- Backrest heater
- Removing and installing. Refer to DIVIDED REAR SEAT BACKREST, REMOVING AND INSTALLING .
- Outer Bearing Sleeve
- Quantity: 2
- Removing and installing. Refer to MOUNT/SLEEVE/PINS, REMOVING AND INSTALLING, REAR SEAT BACKREST .
- Press on until it engages audibly
- Securing Bracket
- For the center bracket
- Removing and installing. Refer to DIVIDED REAR SEAT BACKREST, REMOVING AND INSTALLING .