Overview - Locking Mechanism, Sedan
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The overview shows the locking mechanism on the left 1/3 section of the rear seat backrest. The locking mechanism on the right 2/3 section of the rear seat backrest is identical.
- Rear Seat Backrest Frame
- Key
- Install Lock Cylinder
- Removing and installing. Refer to REAR SEAT BACKREST LOCK CYLINDER, REMOVING AND INSTALLING .CAUTION:
- Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.
- Check the installation position when installing the lock cylinder. It is not possible to lock the rear seat backrest correctly if the installation position is not correct.
- Removing and installing. Refer to REAR SEAT BACKREST LOCK CYLINDER, REMOVING AND INSTALLING .
- Protective Cap
- For lock cylinder
- Remove before installing the lock cylinderCAUTION:
The key must be inserted in the lock cylinder correctly before the protective cap is removed. If that is not done, the tumblers and compression springs can fall out and the lock will be ruined.
- Trim
- For locking and lock cylinder
- Removing and installing. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Locking Mechanism
- For the rear seat backrest
- Removing and installing. Refer to REAR SEAT BACKREST LOCKING MECHANISM, REMOVING AND INSTALLING .
- Bolt
- 25 Nm
- Quantity: 2